|
When
Submitting Art- Please
supply camera-ready art (CRA) that is clean and
sharp with a very high black/white contrast that
needs no further touchup, color separation, design
or modification before and/or during the pre-press
process. We reserve the right to determine whether
art received is CRA and reject as CRA, artwork that
will not reproduce properly (e.g. faxed art, business
cards, products with the imprint, photocopies of
artwork, letterhead, newspaper or yellow page ads
and low resolution electronic files such as .jpeg
or .tiff files). With
the exception of our Color EFX 6-color process..
In the art submitted, designate whether any borders
around your art, such as squares or circles should
be included or removed in the final art design,
otherwise we will process art at our sole discretion
using our best judgment. Also, please include legible
instructions that are printed or typed with regards
to your artwork to avoid any misinterpretations.
Faxed art
is accepted only for exact repeat orders or repeats
with copy changes and new orders with straight-line
copy or new orders using stock art. A variety of
non-licensed stock art created "in-house" and most
of the Augustine Blue Book logos are available without
submission of CRA. When CRA or stock art is not
available, we can provide services to design or
modify art as necessary and charges will be applicable
at an hourly rate (see below)
Sizing
of Art- Specify
what size art submitted should be reproduced at
(e.g. exact size as submitted, maximum size of imprint
area, etc.). If sizing is not specified, we will
reproduce at our discretion for best appearance.
Maximum imprint areas are listed in our catalog
for all items. Always remember that artwork is enlarged
or reduced proportionately by both height and width.
Therefore, when you request the maximum imprint
area, it is possible that only one of the dimensions
will be the same as the maximum imprint area shown
in the catalog. Please consider requesting a paper
proof if size is absolutely critical.
Placement
of Art- Specify
imprint location. For example on coffee mugs or
other handled items, side 1 or front would refer
to placement of art so that it faces a right-handed
drinker when holding the mug; side 2 or back would
refer to placement so that it faces away from a
right-handed drinker; opposite handled would be
centered opposite the handle; wrap imprint would
refer to art that starts on side one and continues
to side two and includes the area opposite the handle.
Please refer to diagram below for referencing placement
of art on handled items. Examples of placement of
art instructions on some sewn items would be centered
on side 1, lower right corner of side 1, upper left
corner on side 1, centered on side 1 and side 2,
centered on pocket or centered on pocket and on
chest (for aprons), etc. A diagram of where you
would like your art placed can be helpful.
Art Charge-
If art
needs modification, "cleaning up" or if it needs
to be completely reconstructed to produce a quality
imprint, such work will be invoiced at $25 without
notification. Notification will be made for charges
exceeding this amount and will be billable at $25.00
per hour. If not provided in your CRA, color separations
for multicolor imprints will be invoiced at $20.00.
Electronic/Digital
Art Files-
Media-
We
can accept 3.5" floppy disks, LS-120 Super Disks,
100MB Zip Disks or CD ROM.
Graphics
Programs used- Adobe
Illustrator is the primary graphics program used
for processing all artwork in our shop. When using
any
other
graphics program, please ensure that the art file
is exported as an .eps file and that the art is
vectored. Art produced in Mac or PC
using
Adobe Illustrator 10, Corel Draw 10 or Freehand
9 (or lower versions) and then saved as an .eps
file with vectored art will be
acceptable
as CRA in most cases. For compressed
files, we can accept Aladdin Stuffit or WinZip.
Submitting
Art via Email-
when submitting art via email, please include the
following information for your order;
*
In email, include distributors company name &
Invoice #.
* Order information (e.g. item, quantity, imprint
colors, ship method, whether there is an event date,
etc.)
* Art instructions regarding imprint size, location
typestyles to use, etc. * Include the names of the
files attached in an email
* Art files should be sent as an attachment to the
email message and should be sent to art@discountmugs.com
* Include information regarding fonts used, postscript
files, suitcases, etc. and create curves or outlines
(vectored) for those type
fonts.
PLEASE
SKETCH YOUR LAYOUT IN THE AREA BELOW
|
IMPRINT
SIZE: (Select
One)
*
Use exact size as art submitted
*
Use maximum imprint area
*
Use Artist discretion
*
Height___ & *
Width___
|
|
IMPRINT
PLACEMENT GUIDELINE
Please
Select One:
*
1 Sided: ___
Side 1___ Side 2
*
2 Sided: Indicate Side 1 & Side 2
*
Wraparound Imprint
*
Opposite the Handle Imprint
*
Step-N-Repeat Wraparound
|
|
|
ART
ELEMENTS TO CONSIDER
|
|
Surfaces
|
Minimum
Pt. Sizes |
Minimum
Reversed Pt. Sizes
|
Line
Weight |
Line
screen Rulings |
| Ceramic
|
9
pt |
10
pt |
1
pt |
20
lpi - 45 lpi |
| Glass
|
9
pt |
10
pt |
1
pt |
20
lpi - 45 lpi |
| Plastic
|
12
pt |
14
pt |
1
pt |
20
lpi - 30 lpi |
| Stainless
Steel |
8
pt |
10
pt |
.75
pt |
20
lpi - 40 lpi |
|
|